Din auzite, telecomanda ar merge din start cu unele televizoare Panasonic (probabil este pre-programată). Apar două intrebări :
- a găsit cineva vre-un cod valabil pentru TV-urile Samsung ?
- in afară de Panasonic, merg şi alte mărci TV ?
******************************************************************************
Pentru telecomenzile originale ar funcţiona următoarea metodă :
Once you have Set-Up your DREAM REMOTE, you can blink back your
SET-UP CODE for future reference.
Example: To blink out your Television code:
1 Press TV once.
2 Press and hold SHIFT until the DREAM REMOTE’s TV key
blinks twice (The TV key will blink once and then twice).
3 Press 9 9 0. The TV key will blink twice.
4 For the first digit of your four-digit code, press 1 and
count all the red blinks. If there are no blinks, the digit is
"0".
5 For the second digit, press 2 and count all the red blinks.
If there are no blinks, the digit is "0".
6 For the third digit, press 3 and count all the red blinks.
If there are no blinks, the digit is "0".
7 For the fourth digit, press 4 and count all the red blinks.
If there are no blinks, the digit is "0". Now you have your
four-digit code.
******************************************************************************
Pentru telecomenzile Sunray4/SR4 :
How to use learning type remote controller for Sunray4/SR4
Operation steps:
1. select TV mode, press the learning type remote controller [ SHIFT ] on the key, approximately 3 Seconds after the TV indicator light on, enter [ learning ] mode.
2. press to a learning remote controller want to learn the key, the indicator slow flicker, said into the [learning mode] of waiting to receive a learning signal state.
3. will be a learning remote controller receiving tube on the original remote transmitting tube, between 2 to 3cm . The original remote control to learn button once, then learning. Remote indicating lamp by slow flicker for flash 3 times after Long light, said a key learning success.
4. other learning button only needs to repeat the above 2, 3 step.
5. after the completion learning, then press [ SHIFT ] to save and exit learning state.
6. into the state of learning, interval 15S learning no press input signal input, remote control lights automatic ;extinguished, leaving [ learning mode ] and automatically save.
7. the same key to learning ,then save the last the code value.
The key to studying as follows:
include power, digital key 0-10,
The volume +, -, BOUQUET + volume,
The BOUQUET and TV keys
Press" DVB" and" TV ( SHIFT )" for mode conversion.
